Carnival Peacock Headpiece
You too can make your own Carnival Peacock headpiece. Kids, you may need an adult to help you with parts of this craft. Demo video, coming soon!
What you will need:
- blue dinner paper plates (1 plate makes to masks)
- pieces of ribbon and cloth
- feathers
- googly eyes
- hole puncher
- pipe cleaners
- scissors
- white glue (you may choose to use a popsicle stick to apply the glue)
- tape
- orange cardstock or manila envelope
- a sheet of jewelled stickers
- buttons of different colours (optional)
Steps:
- blue dinner paper plates (1 plate makes to masks)
- pieces of ribbon and cloth
- feathers
- googly eyes
- hole puncher
- pipe cleaners
- scissors
- white glue (you may choose to use a popsicle stick to apply the glue)
- tape
- orange cardstock or manila envelope
- a sheet of jewelled stickers
- buttons of different colours (optional)
Steps:
- PEACOCK HEAD: With your scissors, cut your blue paper plate in half.
- PEACOCK FEATHERS: With your hole puncher, cut holes about 1 cm (1/2 inch) from the curved edge of your plate. You will make the holes, spacing them a 3-4 centimetres apart.
- Cut strips of ribbon and cloth about 15 cm (6 inches) in length.
- Take the quill (the tip) of the feather and insert it in one of the holes you made with your hole puncher. DO NOT: Put feathers or ribbons on the holes at the bottom of each side. You will make the FASTENERS here.
- Roll the end of a ribbon, thread it through the hole, and tie the feather quill place. Make sure the end of the ribbon can hang.
- You will repeat this at all of the holes. This will make sure your peacock has a lot of feathers.
- FASTENERS: The holes on each side of the semi-circle closest to the bottom, these will be where you will put the 2 pipecleaners. Put about 2 cm (1 inch) of end of 1 pipecleaner through the hole and twist it with the rest so it stays. Repeat on the other side with your second pipecleaner. The lengths of these 2 pipecleaners should point back. You will use these pipecleaner lengths to tie and fasten the headpiece to your head.
- BEAK: Take your orange cardstock or manila envelope. Cut out a triangle-- 5 cm (2 inches) from base to point. On the bottom centre of the back of your paper plate (the white side), tape the triangle so only the base is attached and the point hangs down.
- EYES: Select your two googly eyes. Apply white glue to the back of your googly eyes. Place the eyes on the front of the plate (the blue side) so that the orange beak is centred.
- DESIGNS: This is the fun part now. Take your sparkly and gem stickers. You can also glue on buttons to make designs. Put them all over your peacock's headpiece.
- Tie on your peacock head just so. You're ready to go!
